TB 9-6625-2332-50
Test instrument
Digitizing oscilloscope indications
settings
(sec)
Per
Lead
Trail
Risetime
Falltime
setting
setting
setting
Min
Max
Min
Max
1 sec
6.5e-9
6.5e-9
4.9e-9
8.1e-9
4.9e-9
8.1e-9
10e-9
10e-9
7.7e-9
12.3e-9
7.7e-9
12.3e-9
20e-9
20e-9
15.7e-9
24.3e-9
15.7e-9
24.e3-9
100e-9
100e-9
79.7e-9
120.3e-9
79.7e-9
120.3e-9
l-6
le-6
0.799e-6
1.2e-6
0.799e-6
1.2e-6
100 sec
10e-6
10e-6
8e-6
12e-6
8e-6
12e-6
10 msec
100e-6
100e-6
80e-6
120e-6
80e-6
120e-6
1e-3
1e-3
0.8e-3
1.2e-3
0.8e-3
1.2e-3
200 msec
10e-3
10e-3
8e-3
12e-3
8e-3
12e-3
500 msec
100e-3
100e-3
76e-3
114e-3
76e-3
114e-3
(24) Press DISABLE pushbutton (model 9215 output module) to off ( red light lit).
(25) Disconnect cable from TI 9215 module OUTPUT.
b. Adjustments. No adjustments can be made.
11. Pulse Width
a. Performance Check
(1) Connect equipment as shown in figure 3.
(2) Reset digitizing oscilloscope and cal the gain.
(3) Press TI pushbuttons as listed in (a) through (h) below:
(a)
CHANNEL A.
(b)
(c)
(d)
(e)
(f)
(g)
(h)
Press DISABLE pushbutton (model 9211 output module) to on (red light
extinguished).
(4) Set digitizing oscilloscope channel 3 and trigger probe attenuation to 10.
(5) Setup digitizing oscilloscope to measure pulse width.
(6) Verify that the digitizing oscilloscope indicates within the limits listed in table
(7) Set TI to the next Per and Wid settings listed in table 12.
(8) Repeat (5) through (7) above.
(9) Repeat (8) above for the remaining Per and Wid settings listed in table 12.
