Insertion Loss and Isolation

TB 9-5985-314-24

(8) Receiver system indication will be 20 dB or greater.

(9) Adjust signal generator No. 1 and receiver system frequency controls to

frequency settings listed in table 5. Receiver system indication will be 20 dB or greater.

(10) Repeat (1) and (2) above.

(11) Connect TI into figure 1 equipment setup as listed in (a) through (c) below:

(a) OUTPUT PORT to POINT A.

(b) SIDE PORT to POINT B.

(12) Receiver system indication will be 0.5 dB or less.

(13) Adjust signal generator No. 1 and receiver system frequency controls to

frequency settings listed in table 5. Receiver system indication will be 0.5 dB or less.

(14) Repeat (1) and (2) above.

(15) Connect TI into figure 1 equipment setup as listed in (a) through (c) below:

(a) SIDE PORT to POINT A.

(b) OUTPUT PORT to POINT B.

(16) Receiver system will indicate 20 dB or greater.

(17) Adjust signal generator No. 1 and receiver system frequency controls to

frequency settings listed in table 5. Receiver system indication will be 20 dB or greater.

(18) Repeat (1) and (2) above.

(19) Connect TI into figure 1 equipment setup as listed in (a) through (c) below:

(a) SIDE PORT to POINT A.

(b) INPUT PORT to POINT B.

(20) Receiver system indication will be 0.5 dB or less.

(21) Adjust signal generator No. 1 and receiver system frequency controls to

frequency settings listed in table 5. Receiver system indication will be 0.5 dB or less.