TB 9-6625-2124-24
Paragraph
Page
CALIBRATION PROCESS FOR PLUG-IN,
HEWLETT-PACKARD, MODEL 83525A
Preliminary instructions......................................
Equipment setup ..................................................
CW frequency accuracy and stability .................
Swept frequency and marker accuracy...............
Output power........................................................
AM ON/OFF ratio and square wave
symmetry .........................................................
Final procedure ....................................................
CALIBRATION PROCESS FOR PLUG-IN,
HEWLETT-PACKARD, MODELS 83592A
and 83592A Opt 002
Preliminary instructions......................................
Equipment setup ..................................................
CW frequency accuracy and stability .................
Swept frequency and marker accuracy...............
Output power........................................................
Step attenuation accuracy (Opt 002 only) ..........
AM ON/OFF ratio and square wave
symmetry .........................................................
Final procedure ....................................................
IDENTIFICATION AND DESCRIPTION
1. Test Instrument Identification.
This bulletin provides instructions for the
calibration of Sweep Oscillator, Hewlett-Packard Models 8350A, 8350B and Plug-in,
Hewlett-Packard, Models 83525A, 83592A, and 83592A Opt 002. The manufacturers'
manuals were used as the prime data sources in compiling these instructions. The
equipment being calibrated will be referred to as the TI (test instrument) throughout this
bulletin.
a. Model Variations. Variations among models are described in text.
b. Time and Technique. The time required for this calibration is approximately 6
hours, using the microwave technique.
2. Forms, Records, and Reports
a. Forms, records, and reports required for calibration personnel at all levels are
prescribed by TB 750-25.
b. Adjustments to be reported are designated (R) at the end of the sentence in which
they appear. When adjustments are in tables, the (R) follows the designated adjustment.
Report only those adjustments made and designated with (R).
