TB 9-6625-2124-24
(b) START key, DATA ENTRY 1 GHz.
(c) STOP key, DATA ENTRY 2 GHz.
(d) SWEEP TIME key, DATA ENTRY 105 ms.
Figure 4. Swept frequency and marker accuracy - equipment setup.
(3) Press RF BLANK key (ON) and adjust oscilloscope controls as necessary to
display the TI sweep.
(4) Adjust synthesized signal generator frequency and output level controls until a
birdie (notch) appears on oscilloscope display (approximately 1 GHz).
sweep as indicated on oscilloscope display.
(6) Synthesized signal generator frequency will indicate between 0.985 and 1.015 GHz.
NOTE
If an out-of-tolerance condition is noted in (6) above, or (7)
through (23) below, perform b below.
TI sweep as indicated on oscilloscope display.
(8) Synthesized signal generator frequency will indicate between 1.985 and 2.015 GHz.
13