TB 9-6625-2341-35
7. Equipment Setup
WARNING
HIGH VOLTAGE is used or exposed during the performance of
this calibration.
DEATH ON CONTACT may result if
personnel fail to observe safety precautions.
REDUCE
OUTPUT(S) to minimum after each step within the
performance check where applicable.
a. Remove TI from PM 9083 holster.
b. Connect PM 8907/803 AC/DC ADAPTOR supplied with TI to a 115 V ac power source.
c. Insert PM 8907/803 AC/DC ADAPTOR low voltage plug into TI right side POWER
ADAPTOR connector.
d. Press TI ON/OFF key to ON.
8. Scope Vertical Gain
a. Performance Check
(1) Reset by pressing pushbutton sequence (a) through (m) below:
(a) Display SCOPE/METER/Ω/EXT.mV and etc. Press (F1) SCOPE to
display/highlight SCOPE.
NOTE
If the SCOPE mode is already active, press the SUB MENU
key. Press (F1) CLOSE. If "The red INPUT A and grey
INPUT B BNC jacks are being used as inputs now", then press
(F1) CLOSE.
(b) USER OPTIONS.
(c) (F1) MORE OPTION.
(d) Toggle ▲ or ▼ to display/highlight RESET MENU.
(e) (F5) SELECT ITEM.
(f) Toggle ▲ or ▼ to display/highlight RESET SCOPEMETER.
(g) (F5) SELECT ITEM.
(h) (If all Scope Meter settings have been set to original setting then (F1)
CLOSE), which should display/highlight RESET SCOPEMETER.
(i) Toggle ▲ or ▼ to display/highlight RESET SCOPE.
(j) (F5) SELECT ITEM.
(k) (For original settings, SCOPE mode needs to be selected. Change to
SCOPE mode now? (F1) YES then (F1) CLOSE) or (if all ScopeMeter settings have been
set to original setting then (F1) CLOSE), which should display/highlight RESET SCOPE.
(l) (F1) CLOSE which should display/highlight RESET MENU.
(m) (F1) CLOSE which should display/highlight CONTR.
(2) Connect equipment as shown in figure 1.
