TB 9-6625-2341-35
(i) (F5) SELECT ITEM.
(j) (For original settings, Scope Meter needs to be selected. Change to SCOPE
now? (F1) YES then (F1) CLOSE) or (if all ScopeMeter settings have been set to original
setting then (F1) CLOSE), which should display/highlight RESET SCOPE.
(k) (F1) CLOSE which should display/highlight RESET MENU.
(l) (F1) CLOSE which should display/highlight CONTR.
(2) Connect equipment as shown in figure 3 below:
OSCILLOSCOPE CALIBRATOR
(3) RESET oscilloscope calibrator.
(4) Press pushbutton sequence as listed in (a) through (c) below:
(a) "Input B" to off by pressing (1) through (7) below:
(1) INPUT B.
(2) (F1) MORE INPUT B.
(3) Toggle ▲ or ▼ to display/highlight INPUT B.
(4) (F5 SELECT ITEM).
(5) Toggle ▲ or ▼ to display/highlight off.
(6) (F5) SELECT ITEM.
(7) (F1) CLOSE.
(b) "Input A" probe to 1:1 by pressing (1) through (9) below:
(1) INPUT A.
(2) (F1) MORE INPUT A.
(3) Toggle ▲ or ▼ to display/highlight PROBE A MENU.
(4) (F5) SELECT ITEM which should display/highlight PROBE on INPUT A.
(5) (F5) SELECT ITEM which should display/highlight (1:1, 10:1, 100:1,
1000:1, etc.).
(6) Toggle ▲ or ▼ to display/highlight 1:1.
(7) (F5) SELECT ITEM.
(8) (F1) CLOSE which should display/highlight INPUT A.
10
