TB 9-4920-467-24
p.
Select and activate Start. The Self-Test will begin (fig. 8).
Figure 8 Self Test Running.
q. If Self-Test passes, the following page will be displayed (fig. 9).
Proceed to
step r below.
Figure 9. Self Test Passed.
r. If Self-Test fails, the page in figure 10 will be displayed. Check configuration and
hook-ups, and re-run Self-Test. If Self-Test fails again, refer to the TI manufacturer's
manual.
Figure 10. Self Test Failed.
s.
Repeat steps c through r above for all TI ETTS Pods.
t. Remove power from the UxValidator and the TI ETTS Pod, PN 09-0104-31.
Disconnect the TI ETTS Self-Test Harness and return it to the TI ETTS Transit Case.
u. Connect the TI Hi-Speed Data Cable, PN 10-4040-40, between the A1 port of the
UxValidator and the data port of TI ETTS Pod, PN 09-0104-31.
7