TB 9-6625-2344-35
DEPARTMENT OF THE ARMY TECHNICAL BULLETIN
CALIBRATION PROCEDURE FOR
Headquarters, Department of the Army, Washington, DC
1 July 2003
Approved for public release; distribution is unlimited.
REPORTING OF ERRORS AND RECOMMENDING IMPROVEMENTS
You can improve this manual. If you find any mistakes or if you know of a way to
improve these procedures, please let us know. Mail your letter or DA Form 2028
(Recommended Changes to Publications and Blank Forms)directly to: Commander,
U.S. Army Aviation and Missile Command, ATTN: AMSAM-MMC-MA-NP,
Redstone Arsenal, AL 35898-5000. A reply will be furnished to you. You may also
provide DA Form 2028 information to AMCOM via e-mail, fax, or the World Wide
Web. Our fax number is DSN 788-6546 or Commercial 256-842-6546. Our e-mail
address is: 2028@redstone.army.mil. Instructions for sending an electronic 2028
may be found at the back of this manual. For the World Wide Web, use
https://amcom2028.redstone.army.mil.
Paragraph
Page
IDENTIFICATION AND DESCRIPTION
Test instrument identification ............................
Forms, records, and reports.................................
Calibration description ........................................
EQUIPMENT REQUIREMENTS
Equipment required .............................................
Accessories required.............................................
CALIBRATION PROCESS
Preliminary instructions......................................
Equipment setup ..................................................
Vertical gain accuracy..........................................
Vertical offset .......................................................
Bandwidth accuracy.............................................
Equivalent time measurement............................
Real time measurement.......................................
Trigger sensitivity ................................................
DC calibrator ........................................................
Power supply ........................................................
Final procedure ....................................................
ALIGNMENT PROCESS
Self calibration .....................................................
Final procedure ....................................................