TB 9-6625-163-24
NOTE
An 18 AWG banana lead has the typical characteristics of
1 mΩ for each banana connector end plus 6.4 mΩ per foot. A
4 inch banana lead is typically 4 mΩ. Less than 23 mΩ of wire
is required for this check.
(4) If TI does not indicate between -0.10 and 0.10 ohms, perform b below.
and COM inputs to the resistance
(5) Disconnect short and connect TI V Ω
standard 1 CURRENT HI, CURRENT LO.
(6) Set resistance standard 1 to 0.01 Ω.
(7) Set up TI to perform relative readings by pressing buttons as listed in (a) and (b) below.
(a) [Menu].
(b) Select <REL>, [REL].
(8) Set resistance standard 1 to 0.2 Ω. If TI does not indicate within limits specified
in first row of table 7, perform b below.
(9) Repeat technique of step (8) above, using settings and indications listed in
Table 7. Resistance Accuracy.
Resistance standard
Test instrument
Output
Range
Min
Max
Ω
Ω
Ω
Ω
0.2
500
0.10
0.30
Ω
Ω
Ω
Ω
500
500
499.65
500.35
kΩ
kΩ
4.9973 k Ω
5.0027 k Ω
1
5
5
kΩ
kΩ
49.973 k Ω
50.027 k Ω
50
50
kΩ
500 k Ω
kΩ
kΩ
500
499.73
500.27
M Ω2
MΩ
4.9921 M Ω
5.0079 M Ω
5
5
MΩ
30 M Ω
29.546 M Ω
30.454 M Ω
30
MΩ
500 M Ω
MΩ
MΩ
300
275.8
324.2
Turn REL mode off.
1
Connect TI to Resistance standard 2 H and L terminals.
2
(10)Disconnect equipment.
b. Adjustments. Complete all performance checks in paragraphs 8 through 14,
recording failures, then perform entire alignment procedure in paragraph 17.
13. Capacitance and Diode
a. Performance Check
(1) Connect capacitance standard HIGH, LOW to TI V Ω, COM inputs. Adapt as necessary.
(2) Set capacitance standard to 0 pF.
(3) Set up TI to perform relative capacitance readings by pressing buttons as listed
in (a) through (f) below.
(a)
Function to
.
(b)
[Menu].
(c)
[Cap].
(d)
Range, 10nF.
(e)
[Menu].
(f)
Select <REL>, [REL].
